#1: Water in passenger Footwell. Author: Danny., Location: PeterboroughPosted: Wed Dec 08, 2010 6:05 am ---- Well Im not sure if this is related, but recently i have posted that i have no heating since i drained my system and put antifreeze in...
And i was told it was most likely to be the heater matrix. Now before i go ripping out the dashboard... are these likely to be connected..
I need to get this sorted not because of the heat(or lack of it) But because i believe the water may be emptying from my expensionbottle and through the matrix and leaking... So the engine has no water..
#2: Re: Water in passenger Footwell. Author: bellevuespares, Location: ManchesterPosted: Wed Dec 08, 2010 6:09 am ---- cant really be coming from anywhere else but the matrix, if it turns out to be that i have one ready for despatch., thats if you own an early 206 gti?
#3: Re: Water in passenger Footwell. Author: Danny., Location: PeterboroughPosted: Wed Dec 08, 2010 6:12 am ---- I own a 206 1.4 99' Plate i can get one from a friend and pretty sure they are the same on all models.
Its just going to be a pain in the ass to change.
#4: Re: Water in passenger Footwell. Author: continentalgt, Location: Paignton DevonPosted: Fri Dec 10, 2010 3:30 pm ---- Do a quick check on the doors before you rip out the matrix. Get a watering can full of water, open the door where the foot well gets wet and pour water on the outside rubber window seal and look for water coming out from behind the door card at the bottom. If it does the membrane behind the door card has become detached or is broken. Won't help with the heater but might explain the water in the foot well. Did the procedure on mine today see my post today "Electrical issues and damp carpets"
#5: Re: Water in passenger Footwell. Author: elcamino, Location: home!Posted: Sat Dec 11, 2010 2:15 pm ----
Danny224 wrote:
I own a 206 1.4 99' Plate i can get one from a friend and pretty sure they are the same on all models.
Its just going to be a pain in the as* to change.
Before you change it do this:there are two disconnects. just where the heater matrix located.and two O rings seal them.(inlet and outlet pipe)i think o rings are worn out and water is leaking from there.remove the black flexible cover which fixed by three screws on disconnect to confirm leakage.i had this problem replaced the o rings and it is fine.if u confirmed and decided to do that just inform me i'll tell you the details .
#6: Re: Water in passenger Footwell. Author: navcc, Location: wembleyPosted: Sun Aug 17, 2014 6:33 am ---- Hello everyone, I need to change O ring on heater matrix for Peugeot 206 1.6 auto 2004 petrol.
what I need to know is that, after draining the coolant, do I need to disconnect pipes & screws from the engine compartment, also do I need to loosen screws on the matrix? Can I just disconnect the joint to replace the O rings.
I would be very grateful for any guidance, I know about removing glove box etc.
Kind regards Navin.
We are not responsible for comments posted by our users, as they are the property of the poster
Interactive software released under GNU GPL,
Code Credits,
Privacy Policy
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17125
Online Now [477]:
Visitors: 476
Members: 0
Staff Online Now:
Page Views:
General
