#1: Management light & bleeping Author: simbathedog, Location: DevonPosted: Mon Mar 05, 2012 9:50 am ---- Daughters 53 plate 1.4 petrol 206, driving along when engine management light comes on with a bleeping sound
Not come across people mentioning the bleeping before ???
Parked for 5 minutes, start up again & running fine now!
#2: Re: Management light & bleeping Author: furryhobnob, Location: NuneatonPosted: Mon Mar 05, 2012 11:14 am ---- Probably just the car having a hissy fit, if your worried go and get the codes read, or leave it and see if the problem happens again
#3: Re: Management light & bleeping Author: -Dave-, Location: North ManchesterPosted: Mon Mar 05, 2012 11:53 am ---- Have you had the codes read?
#4: Re: Management light & bleeping Author: Razor34, Location: CroydonPosted: Mon Mar 05, 2012 12:50 pm ---- Just had the same problem on the motorway on way home. Now gone so probably typical 206 electrical problems so dont worry about it unless you experience any loss of power!!!!
#6: Re: Management light & bleeping Author: Razor34, Location: CroydonPosted: Mon Mar 05, 2012 1:29 pm ---- Is anyone local to the Croydon area who can check my codes for me just incase?
#7: Re: Management light & bleeping Author: simbathedog, Location: DevonPosted: Mon Mar 05, 2012 2:10 pm ---- Thanks, having the codes read tomorrow.
It did seem to run on 3 cylinders during the episode.
#8: Re: Management light & bleeping Author: simbathedog, Location: DevonPosted: Wed Mar 07, 2012 1:45 pm ---- Turns out it was the coil pack, all done today.
Now to fit the new front discs & pads.
#9: Re: Management light & bleeping Author: gazza82, Location: South BucksPosted: Wed Mar 07, 2012 2:45 pm ----
simbathedog wrote:
Turns out it was the coil pack, all done today.
Our felt like it had lost two cylinders when it went.
simbathedog wrote:
Now to fit the new front discs & pads.
Piece of p*$$! Rears are a bit more fun. The small screws holding the disc to the hub might snap ... I bought some spares and one of those snapped off when replacing it. I'll drill that out one day ... Luckily the disc ain't going anywhere with a wheel bolted over it!
#10: Re: Management light & bleeping Author: Lee, Location: EnglandPosted: Wed Mar 07, 2012 2:50 pm ---- You don't need them screwed that hold the disc to the hub anyway.
We are not responsible for comments posted by our users, as they are the property of the poster
Interactive software released under GNU GPL,
Code Credits,
Privacy Policy
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17123
Online Now [475]:
Visitors: 474
Members: 0
Staff Online Now:
Page Views:
General
