#1: 2000 reg xsi 1.6 starts and runs but wont rev ?? Author: jordpug12, Posted: Mon Feb 04, 2013 4:19 am ---- this was showing up as throttle position sensor and iv changed both any ideas any one ?? problem is still there wont rev Last edited by jordpug12 on Wed Feb 06, 2013 11:46 am; edited 1 time in total
#2: Re: 206 xsi why would two earths be melted going to my ecu Author: Addaz, Location: SuffolkPosted: Mon Feb 04, 2013 12:36 pm ---- So you replaced the block? As in cut and shut together? Or other?
And are you sure these were melted? Plus what was the original fault?
#3: Re: 206 xsi why would two earths be melted going to my ecu Author: jordpug12, Posted: Mon Feb 04, 2013 2:06 pm ---- yes these wires where toching in places iv blocked and traced each wire one by one and got rid of any bad wires iv just bought it so dont no much about it and is still running mint on tick over it just wont rev up iv replaced one throttle position sensor today but did not change nothing so im going to try throttle boddie to see if tht works
We are not responsible for comments posted by our users, as they are the property of the poster
Interactive software released under GNU GPL,
Code Credits,
Privacy Policy
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17126
Online Now [50]:
Visitors: 49
Members: 0
Staff Online Now:
Page Views:
General
