#1: Coolant leak from rear of pump housing Author: RC_Heli_Boy, Posted: Mon Aug 19, 2013 7:22 am ---- Hello
I have just replaced cambelt, tensioner and water pump on my 206GTi (2003). On filling the coolant tank, it is escaping from where the coolant pipe enters the coolant pump housing. I put the new O ring on the pipe prior to inserting into the pump. It seem as though the pipe (think it is metal) enters at an angle but can't seem to move it insitu. Anyone know if the pipe can be unattached from block (cant see a bracket) and inserted again etc...
Cheers
Mike
#2: Re: Coolant leak from rear of pump housing Author: Edward, Location: In the garagePosted: Mon Aug 19, 2013 2:16 pm ---- It's difficult to remove. Needs to be pulled out of the thermostat housing first before it can be pulled out of the pump. Wear gloves to avoid injuring your hands as it will come out suddenly.
#3: Re: Coolant leak from rear of pump housing Author: Steve206, Location: UKPosted: Mon Aug 19, 2013 2:59 pm ---- I found it easier to take it out still attached to the thermostat, as said though there is not much room, and it will suddenly give!
#4: Re: Coolant leak from rear of pump housing Author: RC_Heli_Boy, Posted: Mon Aug 19, 2013 4:03 pm ---- OK thanks for your replies, got battery and tray out and will try tomorrow eve, cheers
We are not responsible for comments posted by our users, as they are the property of the poster
Interactive software released under GNU GPL,
Code Credits,
Privacy Policy
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17123
Online Now [302]:
Visitors: 301
Members: 0
Staff Online Now:
Page Views:
General
