#1: Lower rear engine mount polybush bush replacement Author: WeeBlue206, Posted: Tue Jun 06, 2017 8:19 am ---- Has anyone replaced this bush with a polybush? If so do you have to remove the original bush surround i.e. the bit that's pressed into the bracket?
I'm thinking rather then remove the bracket and driveshaft etc I could leave it on the car, gut the original bush and fire in a polybush.
I've e-mailed the bush manufacturers but not heard back from them yet.
#2: Re: Lower rear engine mount polybush bush replacement Author: Sim, Location: West CountryPosted: Fri Jun 09, 2017 10:38 am ---- I think this vid is spot on for you: www.youtube.com/watch?v=xew03Q8W6Z8
Thanks goes to Piggy
#3: Re: Lower rear engine mount polybush bush replacement Author: usher, Location: northallertonPosted: Mon Jun 19, 2017 5:38 pm ---- did mine with a hammer and chisel just watch out for the oil level sensor costs a bit when you hit it by accident
#4: Re: Lower rear engine mount polybush bush replacement Author: Edward, Location: In the garagePosted: Tue Jun 20, 2017 11:23 am ---- I'd do it properly...i.e. take it off the car and press the new one in.
We are not responsible for comments posted by our users, as they are the property of the poster
Interactive software released under GNU GPL,
Code Credits,
Privacy Policy