The Peugeot 206 Info Exchange › Forums › Request a how-to › Post a reply

Request a how-to › Post a reply › Re: push start...?

Username

Subject

Message body

Emoticons






More smilies

[quote="M60SHW"]give me to mins theres a how to on the fiesta forum (yes ano) but it may be the same prinsible.

Ford Power Start Button

The following is a guide for fitting a Ford Power Start Button; shown on a Fiesta ST150. This is shown in place of the boot release button, however it can be located in other positions.

What you will need...

1 x Start Button
4 x 0.5m Lengths of Wire (2 x red and 2 x black)
4 x Cable Connectors (Like this)

Tools required...

Cross-head Screwdriver
Torx Screwdriver
Small Electrical Screwdriver (or similar)
Soldering Iron, Solder and Heat Shrink
Sanding Tool or File

Guide...

Next you will need to remove the ignition loom as below.

This is where the new connections will need to be made.

First you will need to cut off the plastic surrounding the pins on the underside of the switch. I have highlighted just above the clips.

Next, solder the red wire to the prongs numbered 4 & 6 and the black wire to the prongs numbered 1 & 3.

This leaves you with four lengths of cable. Wrap up the cable with insulation tape or heat shrink in preparation for routing it through the dash later. Please note, pins are numbered although this is not visible in the pictures.

Place the starter button into the surround and into the hole in the dash. Then route the cable through behind the dash, taking care not to snag the wire on any sharp edges. I find it suitable to cable-tie the lead to points on the dash as to keep it sturdy and in a fixed place.

You will be connecting the leads to the ignition part of the loom (shown above). Using cable connectors, connect your black leads from the starter switch to the grey/black wire on the ignition loom. Connect your remaining red leads to the yellow/green ignition lead. You will notice that the starter and ignition leads are the furthest apart leads on the ignition plug.

Finally, replace the dash fittings, leaving the boot release button connected in the small compartment.

Guide Created: 19/10/08 by st07 and Emma87

Fordpartsuk:

Focus-Push Button Start Switch
FINIS Number: 1459645
Retail Price: £13.67
You Pay: £12.31

Focus-Push Button Start Switch Chrome Ring
FINIS Number: 1503170
Retail Price: £3.76
You Pay: £3.38

(Alternatively you can purchase these parts direct from Ford using the above FINIS Numbers)

Disclaimer Notice: This is to be used as a guide only and fitting is undertaken at the owners risk. If fitted incorrectly safety and security could be compromised so please take care when following the guide.

I  havent actreally read this or done it so dont know if its much help haha :roll:[/quote]

Options
HTML is ON
BBCode is ON
Smilies are ON

	Disable HTML in this post
	Disable BBCode in this post
	Disable Smilies in this post