|
Author
|
Message |
|
|
 Posted: Mon Nov 12, 2012 5:31 am |
|
|
|
|
Joined: Nov 20, 2011
Posts: 153
Trade Rating: 0
Location: Croydon
|
 |
Hi.
My wonderful Peugeot 206 1.4 GLX 02 Plate 5 Door is leaking again through the rear passenger door. I took the door card off an resealed the membrane with duct tape as well as making sure that the drain holes are clear. It seems to be trickling through the bottom of the door by window handle.
Any ideas, should I change the door rubber itself even though there seems nothing wrong. It is driving me mad at the moment as I constantly have a soggy carpet 
| |  |
|
|
 |
|
|
|
|
|
|
Posted: Mon Nov 12, 2012 1:42 pm |
|
|
|
|
Joined: Jul 20, 2012
Posts: 234
Trade Rating: 0
Location: Gainsborough
|
|
my front passenger door leaked as there was a tiny hole in the membrane, so all i did was smear a bit of waterproof silicone over it and it sorted it!
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Mon Nov 12, 2012 3:13 pm |
|
|
|
|
Joined: Apr 19, 2012
Posts: 529
Trade Rating: 0
Location: darlington
|
|
do you have any other questions/problems your seeking answers to on here at the moment?
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Tue Nov 13, 2012 1:21 am |
|
|
|
|
Joined: Nov 20, 2011
Posts: 153
Trade Rating: 0
Location: Croydon
|
|
No other questions, just this 
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Tue Nov 13, 2012 7:35 am |
|
|
|
|
Joined: Apr 19, 2012
Posts: 529
Trade Rating: 0
Location: darlington
|
|
I thought id seen u askin sumthin else and thought the problems
could have been related...
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Thu Nov 15, 2012 1:28 am |
|
|
|
|
Joined: Nov 20, 2011
Posts: 153
Trade Rating: 0
Location: Croydon
|
|
Anyone else got any suggestions. Membrane seems fine.
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Thu Nov 15, 2012 7:45 am |
|
|
|
|
Joined: Aug 01, 2011
Posts: 390
Trade Rating: 0
Location: Bath UK
|
|
As the water getting into the door is coming in faster than it can get out I'd take a look at the window glass bottom door seal between the window bottom and the door. Run a piece of folded card down between the glass and the rubber to clean up and get rid of any debris that is holding the rubber off the glass. Inspect it for any damage or kinks that would allow more water in than normal
With the door bottom drain holes, besides making sure the holes are clear, use a long cable tie to get in and along far enough to make sure they're well clear further in as they tend to go immediately into narrow channels
Finally do a test with the door open of putting a hose pipe on the window, you don't need to blast the water in but keep it on long enough so it has chance to build up inside the doors if it's going to and look for water freely coming out of the drain holes
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Thu Nov 15, 2012 9:16 am |
|
|
|
|
Joined: Nov 20, 2011
Posts: 153
Trade Rating: 0
Location: Croydon
|
|
Many thanks Deckchair5 will give it a go
| | |
|
|
|
|
|
|
|
|
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17129
Online Now [263]:
Visitors: 262
Members: 0
Staff Online Now:
Page Views:
General
Forums Home
Forum FAQ
Search
