|
Author
|
Message |
|
|
 Posted: Sat Jun 08, 2013 1:36 pm |
|
|
|
|
Joined: Feb 11, 2010
Posts: 657
Trade Rating: +4
Location: newcastle upon tyne
|
 |
The 206 has the airbag light on,normally the wires under the seat, but this one hasnt got airbags in seat, any way i just read it with pp2000 and it said this:
Permanent fault level of driver module trigger 1 open circuit
any ideas?
| |  |
|
|
 |
|
|
|
|
|
|
Posted: Sat Jun 08, 2013 2:47 pm |
|
|
|
|
Joined: Feb 10, 2010
Posts: 4266
Trade Rating: +4
Location: Palestine
|
|
well you need a new Com2000 unit mate,because all the faults with Module trigger is caused by
(1) Poor connection at the two pin blue or brown connector on the back of the Comms 2000.
(2) Poor connection at the two pin blue or green connector on the back of the drivers (steering wheel) module.
(3) Intermittent break in the rotary connection built into the Comms 2000.
I think Module 2 are the blue connectors whilst module 1 are the green and brown connectors.
so if you have any problem with those,then you need to replace the COM2000 unit,as these can't be fixed
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Sat Jun 08, 2013 3:47 pm |
|
|
|
|
Joined: Oct 10, 2012
Posts: 1917
Trade Rating: +13
Location: Spalding
|
|
You can get one from ECP. And there is a guide on here to help you replace it. Remember to disconnect the battery properly and reconnect as per the BSI reboot procedure.
| | |
|
|
|
|
|
|
|
|
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17129
Online Now [148]:
Visitors: 147
Members: 0
Staff Online Now:
Page Views:
General
Forums Home
Forum FAQ
Search
