#1: Fuse question Author: sam-c, Location: Uni: Kent Home: ScunthorpePosted: Fri Feb 18, 2011 7:22 am ---- I have a fused distribution block in my boot which takes one wire in and 2 wires out, for each of these outputs there is a 100amp ANL fuse, now I only use one of the outputs so could I take the fuse out of the output which I am not using and place this fuse in the inline fuse holder of the wire which goes into the fused distributution block as the fuses are the same size.
I suppose my question really is would it be safe/cause any problems if I took the fuse from the output I am not using out?
Thanks
Sam
#2: Re: Fuse question Author: Danny., Location: PeterboroughPosted: Fri Feb 18, 2011 7:25 am ---- I think so as logn as the fuses are NOT connected in anyway to complete a circuit as such
We are not responsible for comments posted by our users, as they are the property of the poster
Interactive software released under GNU GPL,
Code Credits,
Privacy Policy
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17130
Online Now [242]:
Visitors: 241
Members: 0
Staff Online Now:
Page Views:
General
