#1: Abs light on fault code c13 ??? Author: davieboy76, Location: scotlandPosted: Thu Feb 24, 2011 11:13 am ---- Can anyone give me any help on this I have an 04 plate 206 hdi s and the abs lights on and won't go off ... Had it reset and it just came bk on again but didn't give a specific fault just said fault code c 13 any help would be appreciated . Thanks
#2: Re: Abs light on fault code c13 ??? Author: SDK206, Location: Earth, most of the time!!Posted: Thu Feb 24, 2011 11:31 am ---- Very strange code mate, i'll have a look for you i'm sure ive seen something similar before but i'll check first
#3: Re: Abs light on fault code c13 ??? Author: SDK206, Location: Earth, most of the time!!Posted: Thu Feb 24, 2011 11:40 am ---- You will need to double check the code as its too short there should another two digits after the 13, i would rescan it and report back!
#4: Re: Abs light on fault code c13 ??? Author: davieboy76, Location: scotlandPosted: Thu Feb 24, 2011 5:26 pm ---- Cheers mate al get my mate to put it back on the tester n get the full code . Cheers for your help
#5: Re: Abs light on fault code c13 ??? Author: SDK206, Location: Earth, most of the time!!Posted: Fri Feb 25, 2011 6:37 am ---- no worries mate hope you get nearer to solving it, just shout up if when get more info
#6: Re: Abs light on fault code c13 ??? Author: davieboy76, Location: scotlandPosted: Tue Mar 01, 2011 12:38 pm ---- light has now gone off andf been off for a few days now hmmm
light has now gone off andf been off for a few days now hmmm
Had you driven the car between resetting and the light coming back on?
Reason I ask is that I had the ABS sensors disconnected to do the rear axle etc and when I rebuilt it all back the ABS light was on.
I think it requires a short drive (upto 15 mph ??) to allow the ABS to be calibrated by the ECU, because as I took the car for a test drive the light went out and has not been on since. Also tested out the ABS once I was fully back on the road and all OK.
Just to note this is only a guess, but I have speed sensors (just like an ABS sensor) on the trains I work on and this principle works for them.
We are not responsible for comments posted by our users, as they are the property of the poster
Interactive software released under GNU GPL,
Code Credits,
Privacy Policy
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17132
Online Now [638]:
Visitors: 637
Members: 0
Staff Online Now:
Page Views:
General
