#1: Rear Axel question again Author: 1000phils, Location: Ross-on-Wye Herefordshire UKPosted: Tue Sep 20, 2011 12:08 pm ---- Hi All
This is a problem of sorts, so please excuse my ignorance is i have posted this wrongly. (is that a word?)
I have been replacing the Axel Bearings (offside) and following a guys posting on Youtube (Liamautomechanic, how to repair peugeot 206 axel). There is a bit where he says measure from Wheel Stub to Sub Frame before removing, which i did, 190mm. The problem that has arose is when putting it back together the only position that the ummm torsion or anti-roll bar would line up is either 170mm or 200ish. I took the wheel off the other side and it measured 170mm although this is with the damper still in place (not sure if that makes a difference). Should i just push it on at the 170mm? What would happen if it is positioned at the wrong height? Sorry about the long windedness.
Hope someone knows what I'm on about.
Many thanks in advance.
#2: Re: Rear Axel question again Author: macj, Location: EssexPosted: Tue Sep 20, 2011 12:15 pm ---- put it on at 200mm, fit the damper and re-measure
#3: Re: Rear Axel question again Author: 1000phils, Location: Ross-on-Wye Herefordshire UKPosted: Tue Sep 20, 2011 1:53 pm ---- Cheers buddy will give that a go in the morning.
We are not responsible for comments posted by our users, as they are the property of the poster
Interactive software released under GNU GPL,
Code Credits,
Privacy Policy
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17129
Online Now [234]:
Visitors: 233
Members: 0
Staff Online Now:
Page Views:
General
