#1: noisy hdi Author: Elldan, Location: CoventryPosted: Fri Sep 23, 2011 10:58 am ---- my 2.0l hdi is due for a service and has been getting louder and louder for the past 12 months. somebody has told me to replace the crankshaft pullley, can anybody back this up? and also what size will i need??
its a 54 plate and the shop i went to said they are not sure of the size because its on the changeover?!
and can anybody recommend a particular engine flush as i'll get this done with the service
wicked.cheers.thanks
#2: Re: noisy hdi Author: MrBSI, Location: What's it to you? ? ?Posted: Fri Sep 23, 2011 11:20 am ----
Elldan wrote:
my 2.0l hdi is due for a service and has been getting louder and louder for the past 12 months. somebody has told me to replace the crankshaft pullley, can anybody back this up? and also what size will i need??
its a 54 plate and the shop i went to said they are not sure of the size because its on the changeover?!
and can anybody recommend a particular engine flush as i'll get this done with the service
Pulley - stick your VIN in to Peugeot Service box to get the correct part number.
Engine flush = NOOOOOOO, does more harm then good, changing the oil & filter at the correct time / distance with decent oil & a genuine Peugeot / Citroen OR Purflux oil filter would be much better in the long run
#3: Re: noisy hdi Author: Seabook, Posted: Fri Sep 23, 2011 11:45 am ---- none of the turbo specialist/ builder recommanded engine flush as there is always a chance to block the oil feed pipe.
#4: Re: noisy hdi Author: Lee, Location: EnglandPosted: Fri Sep 23, 2011 11:58 am ---- Eibach bottom pulley, can get them for about £40
Just got it from the local motor factors [KandR Spares], cost £50 including fitting, happy days
Risky
Only got the part from them, know them so get it a bit cheaper
Foggy fitted it me
Not so bad then lol, they made a right mess of my mates GT
KnR? or clarance street?
The old feller is a right knob at clarance street. Normally get foggy or birchy to do my stuff
K&R.
Clarence Street did the drive shaft on the 180 they nearly had it for the clutch too but when I took it there Lazlo was there being an a******e so I took it elsewhere.
#15: Re: noisy hdi Author: Lee, Location: EnglandPosted: Fri Sep 23, 2011 12:47 pm ---- Think only the main cars they fix are banger cars at K&R.
Altho, seen a sign today, apparently they are fitting tyres as well now
We are not responsible for comments posted by our users, as they are the property of the poster
Interactive software released under GNU GPL,
Code Credits,
Privacy Policy
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17130
Online Now [43]:
Visitors: 42
Members: 0
Staff Online Now:
Page Views:
General
