New Here?
Toggle Content
   

Toggle Content User Info
Welcome

Anonymous

Nickname
Password
Register

Membership:
Latest: sparrowdclxvi
New Today: 0
New Yesterday: 0
Overall: 17139

Online Now [149]:
Visitors: 148
Bots: 1
Members: 0
Staff Online Now:

No staff members are online!
Page Views:
Today: 10381
Total: 113500076

Toggle Content Main Menu
 General Info Goodies Search Web Stats Members
 Donations

 

Forums ›

:: Forums ›
1.1 tickover problem
-> 206 Problems

#1: 1.1 tickover problem Author: elland_canary, Location: west yorkshire PostPosted: Sat Jun 09, 2012 7:37 am
    ----
Have a w reg 1.1, won't idle. As soon as you lift off it stalls, runs fine if revved, will rev smoothly right through the range until you lift off then stalls. Starts first time as long as have foot lightly on accelerator. Was told probably MAP sensor, have changed that but made no difference, any ideas?

#2: Re: 1.1 tickover problem Author: -Dave-, Location: North Manchester PostPosted: Sat Jun 09, 2012 7:41 am
    ----
Give the ICV a clean, That may help.

#3: Re: 1.1 tickover problem Author: Davies, Location: Manchester PostPosted: Sat Jun 09, 2012 8:05 am
    ----
As Dave said, sounds like a ICV Issue, there is a how to on the forum on how to give it a clean, its literally a 5 minute job and can work wonders!

#4: Re: 1.1 tickover problem Author: elland_canary, Location: west yorkshire PostPosted: Sat Jun 09, 2012 9:47 am
    ----
have tried cleaning out ICV, not made a blind bit of difference Sad
stumped again, thanks for suggestions though, any further suggestions appreciated

#5: Re: 1.1 tickover problem Author: Deckchair5, Location: Bath UK PostPosted: Sat Jun 09, 2012 12:00 pm
    ----
Still sounds like the ICV / idle stepper motor. Perhaps it's simply died. It would be nice to check it out first though.
Try a wiggle test of the ICV connector whilst it's trying to idle. See if it makes a difference
Remove the ICV, connect its connector and see if the valve moves when you turn ign on/off
Check if power/ signal is arriving at the ICV
Check the resistances through the ICV terminals

They are only around £15 new if it is dead

Last edited by Deckchair5 on Sat Jun 09, 2012 1:21 pm; edited 1 time in total

#6: Re: 1.1 tickover problem Author: elland_canary, Location: west yorkshire PostPosted: Sat Jun 09, 2012 12:23 pm
    ----
will try that tomorrow, thanks for tip, modern (!) cars got too many gadgets on them, did all my tinkering on 70's fords and vauxhalls, much simpler to diagnose.

#7: Re: 1.1 tickover problem Author: Davies, Location: Manchester PostPosted: Sun Jun 10, 2012 12:55 am
    ----
Failing that, I had a issue slightly similar, but the car was revving up even whilst driving it, thus pulling me down the road.

It came out to be the MAP sensor.

Jack



-> 206 Problems


Page 1 of 1
 
We are not responsible for comments posted by our users, as they are the property of the poster
Interactive software released under GNU GPL, Code Credits, Privacy Policy