#1: Name that part?? Author: Mounty, Location: United KingdomPosted: Fri Nov 30, 2012 12:00 pm ---- Small part broken off from end of driveshaft where it fits into hub.
Its a approx 2.5-3" ring with teeth all the way round the outer edge. Tucks in behind wheel bearing I think. 1 part of it had fallen out in garage and the rest of it just pulled out. Looks as if it maybe had a seal attached to it when it was new?
Just need to know what its called so can get a replacement. Should there be a cir clip to hold it on?
#2: Re: Name that part?? Author: lmilligan, Location: HertfordshirePosted: Fri Nov 30, 2012 12:10 pm ---- think your describing the ABS sensor
#3: Re: Name that part?? Author: cartoonhead, Location: North ManchesterPosted: Fri Nov 30, 2012 12:14 pm ---- ABS sensor ring if it looks like THIS
#4: Re: Name that part?? Author: Mounty, Location: United KingdomPosted: Fri Nov 30, 2012 12:37 pm ---- Good work chaps, that looks like the bit. Will that just tap on to the end of the drive shaft then? Wondering if there is a seal missing from end of shaft as when I pulled it off had a very perished bit of rubber stuck to it?
EDIT: Just seen a Youtube vid, looks like a little heat will sort it!!
#5: Re: Name that part?? Author: Mounty, Location: United KingdomPosted: Sun Dec 02, 2012 1:49 pm ---- Got one coming off Fleabay. Prices vary from £2.50 - £30.00 so went somewhere in the middle for a hardened one. Local Pug dealer hadn't a clue which part i was on about but when they eventually did said part is no longer available, you have to buy it on a replacement drive shaft!! Ooosh!!
We are not responsible for comments posted by our users, as they are the property of the poster
Interactive software released under GNU GPL,
Code Credits,
Privacy Policy
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17130
Online Now [147]:
Visitors: 146
Members: 0
Staff Online Now:
Page Views:
General
Ooosh!!
