#1: Long busy day! Author: Tolkienfan001, Location: SpaldingPosted: Fri Feb 15, 2013 12:21 pm ---- Started work at 05:30 finished at 10:00.
When I got home I started on the car.
Fuel tank strap cleaned, rust removed and sealed with under body seal.
Both sills were repaired recently, so I removed all rust and old sealer and re sealed both these.
Changed both track rod ends. The passenger side was a B***h to losen off.
Painted the front tow eye. Damaged it putting the SP grille on and it had started to rust
Ran out of daylight and energy now so will get the alignment (4 wheel) sorted first thing in the morning.
#2: Re: Long busy day! Author: Austin, Location: TelfordPosted: Fri Feb 15, 2013 12:35 pm ---- Sounds like a mega busy day! I hate doing track rod ends aswell... I finished at 1 and been doing the rear shoes, top mount bearing tomorrow :/ not looking forward to that! Lol
#3: Re: Long busy day! Author: Tolkienfan001, Location: SpaldingPosted: Fri Feb 15, 2013 12:55 pm ---- Yea agreed! Sounds like a good idea before you start. When a nut or bolt won't shift any you throw everything at it including the heat gun!
Feels good when it's all done though
#4: Re: Long busy day! Author: spike_202, Location: West midsPosted: Fri Feb 15, 2013 2:50 pm ---- I usually just cut down the middle of the nut then it just falls off takes 2mins. But it's a pain in the a**e if you don't have an angle grinder handy.
We are not responsible for comments posted by our users, as they are the property of the poster
Interactive software released under GNU GPL,
Code Credits,
Privacy Policy
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17130
Online Now [44]:
Visitors: 44
Members: 0
Staff Online Now:
Page Views:
General
