#1: No hazards/indicators Author: danhodson, Location: Derby, UKPosted: Sat Nov 16, 2013 11:07 am ---- Despite the relay clicking there are no lights all round or on the dash when initiating the hazards or left/right indicator.
Also when locking/unlocking there are no lights flashing, but I hear the relay!
Can any advise, I'm guessing it may be a fuse problem, but looked at the fuse board and can't make any sense of it!
#2: Re: No hazards/indicators Author: Elreidy, Location: WrexhamPosted: Sat Nov 16, 2013 11:30 pm ---- Had this on my 106 pretty sure was a fuse, have you got a manual handy to correspond with the fuse box, and just try one of the other same ampage fuses to see if the problem travels, would recommend following the disconnection procedure for battery if messing with the electrics, otherwise can be costly!
#3: Re: No hazards/indicators Author: danhodson, Location: Derby, UKPosted: Sun Nov 17, 2013 5:09 am ---- I've taken a photo of both the bsi fuse box and the internal fusebox
can anyone point me in the right direction regarding the fuse for:
Direction indicators, hazard warning
#4: Re: No hazards/indicators Author: 20Drift, Posted: Sun Nov 17, 2013 5:39 am ---- According to this website, you'll be wanting to find the A fuse, which is 15A
#5: Re: No hazards/indicators Author: macca1411, Location: Westhoughton, LancashirePosted: Sun Nov 17, 2013 5:48 am ---- Is the car pre-plex or multi-plex?
Remember the hazards are on a separate circuit to the indicators until they reach the BSI. From the BSI it is a shared circuit to the bulbs. Each bulbs has it's own individual feed from the BSI.
Check the maxi fuses (MF1 70amp I think) in the engine bay to make sure nothing has come loose when you had your bump. Also check for any damage to the wiring that could have been caused by the bump.
Reboot the BSI to make sure it's not picked up a glitch.
Is there anything else not working? Last edited by macca1411 on Sun Nov 17, 2013 6:00 am; edited 2 times in total
#6: Re: No hazards/indicators Author: danhodson, Location: Derby, UKPosted: Sun Nov 17, 2013 5:50 am ---- I've found the fuse and replaced it, locking the car made the lights flash but blew the new fuse!
I've had all the lights and front bumper off, but its now reassembled. I thought a indicator bulb on the nearside had gone, but a volt meter reads through it.
#7: Re: No hazards/indicators Author: danhodson, Location: Derby, UKPosted: Sun Nov 17, 2013 7:22 am ---- It's preplexed, everything is working apart from the indicators, and hazards so can only assume its the loom or bulb!
#8: Re: No hazards/indicators Author: macca1411, Location: Westhoughton, LancashirePosted: Sun Nov 17, 2013 11:28 am ---- Take each bulb out and check that it lights up using a battery and couple of pieces of wire. It's possible that a bulb could have been damaged in the impact and is causing a short, although this usually happens in heavy impacts, if the bulb was old and fragile it could have failed.
If all bulbs light up, then it could be a short in the wiring. This is a long tedious process to trace the fault as you need to check the continuity of each wire in turn using a multimeter.
#9: Re: No hazards/indicators Author: doski, Location: WarwickshirePosted: Sun Nov 17, 2013 11:35 am ---- not too sure about yours but im certain my fuse was one of the ones in the very bottom row the 15A on the left double check your fuses and the plugs that surround the fuse compartment just in case.
#10: Re: No hazards/indicators Author: DREWDEN, Location: huddersfieldPosted: Sun Nov 17, 2013 12:11 pm ---- Maybe the hazard switch is bad, is yours the double type with the central locking switch next to it.
Try taking the cover off and playing around, maybe a wire loose.
I also thought indicators do not have a fuse, that they run through a relay inside the bsi.
Mine does not have fuses anyhow.
#11: Re: No hazards/indicators Author: V9977, Location: Athens, GreecePosted: Sun Nov 17, 2013 12:19 pm ----
danhodson wrote:
I've found the fuse and replaced it, locking the car made the lights flash but blew the new fuse!
I've had all the lights and front bumper off, but its now reassembled. I thought a indicator bulb on the nearside had gone, but a volt meter reads through it.
Doesn't mean it's OK, it could be shorted (the actual bulb).
#12: Re: No hazards/indicators Author: macca1411, Location: Westhoughton, LancashirePosted: Sun Nov 17, 2013 12:28 pm ----
DREWDEN wrote:
I also thought indicators do not have a fuse, that they run through a relay inside the bsi.
Mine does not have fuses anyhow.
Yours is multi-plexed, so different wiring system.
#13: Re: No hazards/indicators Author: V9977, Location: Athens, GreecePosted: Sun Nov 17, 2013 12:46 pm ----
macca1411 wrote:
DREWDEN wrote:
I also thought indicators do not have a fuse, that they run through a relay inside the bsi.
Mine does not have fuses anyhow.
Yours is multi-plexed, so different wiring system.
Every single thing has a fuse on a car for safety reasons and system integrity.
There are also a few of them on the front part of the BSI (bottom-right of fuses in your cabin group pic).
This is both for mux and non-mux versions of vehicles.
I would definately change that bulb incase filament has shorted, which is rare but certainly does happen.
#14: Re: No hazards/indicators Author: danhodson, Location: Derby, UKPosted: Sun Nov 17, 2013 2:53 pm ---- I removed the 2 front bulbs and popped a new fuse in, tested the lights and it popped the fuse. I disconnected the battery, replaced the fuse and tried again and it worked. I then plugged the two fronts in and all is well exempt near side won't light up. I've tried two bulbs in it and neither work, so could be a faulty connection
#15: Re: No hazards/indicators Author: danhodson, Location: Derby, UKPosted: Tue Nov 19, 2013 7:19 am ---- I've managed to fix this issue now, and some how my car sailed through its MOT despite being slightly mangled.
I've now got an issue with my radio asking for the code every single time I start the car, almost as if the permanent live isn't working?
#16: Re: No hazards/indicators Author: V9977, Location: Athens, GreecePosted: Tue Nov 19, 2013 7:46 am ----
danhodson wrote:
I've managed to fix this issue now, and some how my car sailed through its MOT despite being slightly mangled.
I've now got an issue with my radio asking for the code every single time I start the car, almost as if the permanent live isn't working?
Good, for future ref what was it exactly and how did you fix it?
#17: Re: No hazards/indicators Author: 20Drift, Posted: Tue Nov 19, 2013 7:58 pm ----
danhodson wrote:
I've managed to fix this issue now, and some how my car sailed through its MOT despite being slightly mangled.
I've now got an issue with my radio asking for the code every single time I start the car, almost as if the permanent live isn't working?
Happens when you disconnect the battery! Should be able to get one from a Peugeot garage, or Macca might be able to sort you with one, if you ask nicely
#18: Re: No hazards/indicators Author: danhodson, Location: Derby, UKPosted: Wed Nov 20, 2013 11:46 am ---- I've got the code, it just asks for it every single time I start the car!
#19: Re: No hazards/indicators Author: macca1411, Location: Westhoughton, LancashirePosted: Wed Nov 20, 2013 11:56 am ---- Have you had an after market HU in the car? Sounds like it's the red/yellow wire in reverse, either that or the fuse has been moved and not put back in the right place. www.206info.co.uk/Foru...c/t=16054/
#20: Re: No hazards/indicators Author: danhodson, Location: Derby, UKPosted: Wed Nov 20, 2013 1:17 pm ---- What would I do without you guys haha! I took the fuse out and put it back in the wrong place!
#21: Re: No hazards/indicators Author: danhodson, Location: Derby, UKPosted: Wed Nov 20, 2013 2:54 pm ----
V9977 wrote:
danhodson wrote:
I've managed to fix this issue now, and some how my car sailed through its MOT despite being slightly mangled.
I've now got an issue with my radio asking for the code every single time I start the car, almost as if the permanent live isn't working?
Good, for future ref what was it exactly and how did you fix it?
Turned out to be an issue with the indicator loom being damaged and possibly shorting out on the chassis!
#22: Re: No hazards/indicators Author: V9977, Location: Athens, GreecePosted: Wed Nov 20, 2013 3:06 pm ----
danhodson wrote:
V9977 wrote:
danhodson wrote:
I've managed to fix this issue now, and some how my car sailed through its MOT despite being slightly mangled.
I've now got an issue with my radio asking for the code every single time I start the car, almost as if the permanent live isn't working?
Good, for future ref what was it exactly and how did you fix it?
Turned out to be an issue with the indicator loom being damaged and possibly shorting out on the chassis!
Oooh, Macca was right then!
I still think it was the bulb though..
#23: Re: No hazards/indicators Author: macca1411, Location: Westhoughton, LancashirePosted: Wed Nov 20, 2013 3:50 pm ----
V9977 wrote:
danhodson wrote:
V9977 wrote:
danhodson wrote:
I've managed to fix this issue now, and some how my car sailed through its MOT despite being slightly mangled.
I've now got an issue with my radio asking for the code every single time I start the car, almost as if the permanent live isn't working?
Good, for future ref what was it exactly and how did you fix it?
Turned out to be an issue with the indicator loom being damaged and possibly shorting out on the chassis!
Oooh, Macca was right then!
I still think it was the bulb though..
And people say this site isn't helpful anymore
Glad it's all sorted. sometimes it helps to think outside the box.
We are not responsible for comments posted by our users, as they are the property of the poster
Interactive software released under GNU GPL,
Code Credits,
Privacy Policy
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17130
Online Now [115]:
Visitors: 114
Members: 0
Staff Online Now:
Page Views:
General
And people say this site isn't helpful anymore
