#1: Low RPM & Cut out Author: luke079, Location: LancashirePosted: Tue May 06, 2014 5:59 pm ---- Hey all I drive a 2002, 1.1 Multiplexed
Today I drove my car to the shops no problem at all but when I came out it wouldn't start sounded almost like as if the immobiliser was Still active (I know it clearly isn't that but it was that noise).
I tried again but still nothing I disconnected and reconnected the battery and it ticked over but only to 500RPM I revved it and it sprung into life.
It lasted about 2 minutes right up until I got to the junction then same problem.
Managed to get it going again and seems ok however when idle my revs are only 800RPM (Normally 1000)
Does anyone have any ideas what this could be?
Cheers Last edited by luke079 on Wed Nov 30, 2016 9:29 am; edited 1 time in total
#2: Re: Low RPM & Cut out Author: Edward, Location: In the garagePosted: Wed May 07, 2014 1:04 am ---- Will it run with throttle applied? Is the problem just at idle and not when driving?
#3: Re: Low RPM & Cut out Author: luke079, Location: LancashirePosted: Wed May 07, 2014 1:54 am ---- Yes it will but it did cut out when slowing down to a stop at a junction
#4: Re: Low RPM & Cut out Author: Edward, Location: In the garagePosted: Wed May 07, 2014 7:03 am ---- I'm guessing you had the clutch on the floor and no throttle applied when it cut out.
#5: Re: Low RPM & Cut out Author: luke079, Location: LancashirePosted: Wed May 07, 2014 9:03 am ---- I had shifted into nuteral and was rolling with no throttle applied
#6: Re: Low RPM & Cut out Author: 20Drift, Posted: Wed May 07, 2014 10:04 am ----
luke079 wrote:
I had shifted into nuteral and was rolling with no throttle applied
We are not responsible for comments posted by our users, as they are the property of the poster
Interactive software released under GNU GPL,
Code Credits,
Privacy Policy
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17129
Online Now [240]:
Visitors: 239
Members: 0
Staff Online Now:
Page Views:
General
then same problem.
