The Peugeot 206 Info Exchange › Forums › The Car › 206 Problems

Forums Home

Forum FAQ

Speedo Problem *need help*
Forum Index › 206 Problems

watchs.gif

Author

Message

weller96c

Posted: Sat May 21, 2011 9:44 am

Joined: May 17, 2011
Posts: 5
Trade Rating: 0
Location: London

Hi all, need some help with my 206, i have a fault with my speedo. The needle stopped working and was showing zero MPH while the other needles worked fine, Then the needle started to move up again but was inaccurate and jumped all over the place,

When driving the speed gets to about 35 then will jump to down to diffrent speeds or to zero.

I have replaced the speedo sensor and gear oil, I have also replaced the speedo clock instrument and still the issue persits. Anyone had this before or can advise what might the fault?
Thanks in advance
Chris

sicskate

Posted: Sat May 21, 2011 11:53 am

Joined: Feb 07, 2010
Posts: 762
Trade Rating: +13
Location: Margate, Kent

Try opening the drivers door whilst moving (slowly) if the interior light comes on and the car beeps, then the dials are at fault. Sadly it's a common fault so it's possible you have bought duff dials.


	307 1.4hdi

weller96c

Posted: Sun May 22, 2011 2:15 pm

Joined: May 17, 2011
Posts: 5
Trade Rating: 0
Location: London

Thanks for the reply, much appreciated, when I open the drivers car door while the car moves the interior light comes on but no beeping? My cars an X reg, dont know if that makes a difference?


	Weller96c

Edward

Posted: Sun May 22, 2011 2:26 pm

Joined: Feb 08, 2010
Posts: 7045
Trade Rating: +5
Location: In the garage

if the interior light flashes then the ECU is getting a speed signal and the clocks aren't.

If the engine speed seems to drop a little low initially when asking it to idle it means the ECU isn't getting a speed signal.

Depending on age of the car if the odometer is clocking up the miles but the speedo doesn't work then the clocks are at fault.

There is also a chance there is a problem with the wiring. Check the large connector at the passenger side behind the front bumper.


	2001 GTi 138, Bilstein Sprint dampers, H&R springs, 21mm Peugeot Sport torsion bars, 22mm rear ARB, Peugeot Sport Group A wishbones, 283mm discs, Goodridge stainless hoses, Maniflow 304 grade 4-2-1 2.5" manifold and system, 200 cell cat, Richard Longman head, 45mm Jenvey throttle bodies, 9.5mm TB spacers, 90mm air horns, Jenvey throttle linkage, Jenvey fuel rail, Aeromotive and Goodridge fuel fittings and braided hose, ITG sausage filter, Radtec custom radiator, Piper Ultimate Road cams, Piper vernier pulleys, Omex 600 ECU. Saxo electric PAS pump, Vibra Technics engine mounts. Samco coolant hoses, TTV steel flywheel, 4.76 final drive ratio, 307 CC 180 ratios. 2019 BMW 530i. 2017 Mercedes C300 convertible.

weller96c

Posted: Sun May 22, 2011 2:36 pm

Joined: May 17, 2011
Posts: 5
Trade Rating: 0
Location: London

Hi edward, the interior light doesn't flash its just on the same as when the door is opened when parked?


	Weller96c

watchs.gif		All times are GMT
Forum Index › 206 Problems Page 1 of 1


	You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum