Author
|
Message |
|
Posted: Thu Oct 27, 2011 10:32 pm |
|
|
|
Joined: Feb 22, 2010 Posts: 65
Trade Rating: 0
Location: Kenya
|
|
Have tried searching but either it's not on or I'm simply too impatient. So thanks to the fantastically drained roads here and very heavy rains, wound up going through what I unfortunately assumed to be a not so deep body of water. Car stalled in the middle and wouldn't start. When I came out to push the car, water was to slightly below my knees. Pushed it to an apartment right next and left it for the night. Just checked it, the filter is drenched. Car still won't start even with the filter out. Makes a sound like a flat battery. But battery is fine all electronics and lights working fine. Any ideas as to what monumental damage I may have done? What a f*****g mess.
| | |
|
|
|
|
|
|
|
Posted: Thu Oct 27, 2011 10:51 pm |
|
|
|
Joined: Feb 07, 2010 Posts: 1495
Trade Rating: +3
Location: Waiting for the tugboats to push me into port (Whitehaven)
|
|
sounds like it's sucked water in and hydralocked
providing you havent bent anything trying to start it take your spark plugs out and turn it over it'll fire the water out, then let it dry out and try again later
| | |
|
|
|
|
|
|
|
Posted: Thu Oct 27, 2011 11:33 pm |
|
|
|
Joined: Feb 10, 2010 Posts: 904
Trade Rating: +5
Location: Little hulton (worsley)
|
|
Remove the filter and plugs try to fire it up if it up
As said above.
Replace plugs air filter oil and oil filter. And also check for blow fuses. Hope fully you haven't bent any valves.
| | |
|
|
|
| | |
| Image removed due to size
focus st 3 with pro alloy intercooler, 3" mongoose down pipe, 200 cell sports cat and mongoose cat back, collins bov, dreamscience dsci cold air intake,focus rs injectors,focus rs oil cooler,dreamscience dsci tuneing platform mod X map,focus rs clutch & flywheel, rs fuel pump, polly bushes in wish bones rear axal and suspension white line front and rear arb, eibach pro street s suspension. | |
| | |
|
|
|
|
|
Posted: Fri Oct 28, 2011 3:19 am |
|
|
|
Joined: Feb 22, 2010 Posts: 65
Trade Rating: 0
Location: Kenya
|
|
Thanks guys just nipped off way from work wanna give it a go....
| | |
|
|
|
|
|
|
|
Posted: Fri Oct 28, 2011 3:55 am |
|
|
|
Joined: Jan 10, 2011 Posts: 1629
Trade Rating: +14
Location: surrey
|
|
Just below your knees?!?! That must have been like hitting a brick wall
| | |
|
|
|
|
|
|
|
Posted: Fri Oct 28, 2011 4:11 am |
|
|
|
Joined: Dec 16, 2010 Posts: 1533
Trade Rating: +10
Location: UK
|
|
The cylinders are Hydrolocked meaning that they have water inside of them. As water doesnt compress, when you try to start the car it wont crank over. Making it seem like a flat battery.
How hard were you revving at the time? if an engine is hydrolocked at high revs it can easily write it off. (bent piston rods etc)
As said above you need to remove the water from the cylinders. The best way of doing this is to remove all of the spark plugs and crank the engine over, water will be forced out of the spark plug holes.
If it doesnt crank with the sparkies removed then somethings badly bent.
If the car does crank freely then you should change the oil filter, air filter, oil and replace the plugs, then it should start.
See here for some vids on hydrolocked engines
www.youtube.com/watch?v=m_OeRk7o0lI
www.youtube.com/watch?...pm_Zc&NR=1
www.youtube.com/watch?v=699RwhrJU28
| | |
|
|
|
| | |
| Please Dont take any of my posts as written fact. They are simply my opinion and although to the best of my knowledge true, the information within them may well be incorrect.
Any work you undertake as a result of my posts is done so at your own risk | |
| | |
Last edited by MrrNoName on Fri Oct 28, 2011 4:20 am; edited 1 time in total
|
|
|
|
|
Posted: Fri Oct 28, 2011 4:17 am |
|
|
|
Joined: Feb 22, 2010 Posts: 65
Trade Rating: 0
Location: Kenya
|
|
craigy00craig wrote: |
Just below your knees?!?! That must have been like hitting a brick wall |
Not really went in very slowly....after I watched a Toyota Corolla drive through and gained confidence.....the worst part is I had a choice of like 3 roads to use to get where I was going...this was the shortest. *regretful sigh*
| | |
|
|
|
|
|
|
|
Posted: Fri Oct 28, 2011 4:26 am |
|
|
|
Joined: Feb 22, 2010 Posts: 65
Trade Rating: 0
Location: Kenya
|
|
MrrNoName wrote: |
The cylinders are Hydrolocked meaning that they have water inside of them. As water doesnt compress, when you try to start the car it wont crank over. Making it seem like a flat battery.
How hard were you revving at the time? if an engine is hydrolocked at high revs it can easily write it off. (bent piston rods etc)
As said above you need to remove the water from the cylinders. The best way of doing this is to remove all of the spark plugs and crank the engine over, water will be forced out of the spark plug holes.
If it doesnt crank with the sparkies removed then somethings badly bent.
If the car does crank freely then you should change the oil filter, air filter, oil and replace the plugs, then it should start.
See here for some vids on hydrolocked engines
www.youtube.com/watch?v=m_OeRk7o0lI
www.youtube.com/watch?...c&NR=1
www.youtube.com/watch?v=699RwhrJU28 |
Was in 2nd, very low revs as was entering slowly...Fingers crossed taking out the plugs now to try...
| | |
|
|
|
|
|
|
|
Posted: Fri Oct 28, 2011 4:44 am |
|
|
|
Joined: Nov 27, 2010 Posts: 11519
Trade Rating: +10
Location: What's it to you? ? ?
|
|
If you have the standard air intake system on the 1.4 then it takes deep water to get sucked up in to the engine.
| | |
|
|
|
| | |
| Toyota C-HR GR Sport 2.0 Hybrid with JBL & Alcantara packs. | |
| | |
|
|
|
|
|
Posted: Fri Oct 28, 2011 5:10 am |
|
|
|
Joined: Feb 07, 2010 Posts: 4455
Trade Rating: +1
Location: Essex
|
|
Mkajuma wrote: |
Was in 2nd, very low revs as was entering slowly... |
You should have been in 1st & kept the revs high & slipped the clutch (on a manual to drive slowly) to reduce the chances of water going into the exhaust. This might have been what caused your problem as the exhaust is usually lower than the air intake.
| | |
|
|
|
|
|
|
|
Posted: Fri Oct 28, 2011 5:17 am |
|
|
|
Joined: Feb 07, 2010 Posts: 838
Trade Rating: +2
Location: Taking a gearbox off somewhere
|
|
Mkajuma wrote: |
Makes a sound like a flat battery. |
Hydrolocked. Guarantee something is bent.
| | |
|
|
|
|
|
|
|
Posted: Fri Oct 28, 2011 5:40 am |
|
|
|
Joined: Feb 08, 2010 Posts: 3617
Trade Rating: +9
Location: Under your bed
|
|
Remove sparks, crank for a bit, change air filter, check for other signs of damage. Sparks in, give it another go.
With that engine it's cheaper to just try that and at least know if it's fecked than worry about breaking something. If something is buggered it will have to be removed anyway, and much cheaper to just put in another engine if that's the case.
| | |
|
|
|
|
|
|
|
Posted: Fri Oct 28, 2011 7:35 am |
|
|
|
Joined: Feb 22, 2010 Posts: 65
Trade Rating: 0
Location: Kenya
|
|
Update: So sparks out, cranked it, now off to grab new plugs and filter then give it a go. Got a mate who worked at Marshalls to come and have a look as well, he jacked the car driver's side and turned the wheel several times, the timing belt turned. He said the engine should be ok....
| | |
|
|
|
|
|
|
|
Posted: Fri Oct 28, 2011 7:57 am |
|
|
|
Joined: Feb 07, 2010 Posts: 838
Trade Rating: +2
Location: Taking a gearbox off somewhere
|
|
Did you crank it from the crankshaft pulley or did you spin it on the starter? Any knocking noises? You'll soon know when you've changed the plugs.
| | |
|
|
|
|
|
|
|
Posted: Sat Oct 29, 2011 6:30 am |
|
|
|
Joined: Dec 16, 2010 Posts: 1533
Trade Rating: +10
Location: UK
|
|
E5GDM wrote: |
Mkajuma wrote: |
Was in 2nd, very low revs as was entering slowly... |
You should have been in 1st & kept the revs high & slipped the clutch (on a manual to drive slowly) to reduce the chances of water going into the exhaust. This might have been what caused your problem as the exhaust is usually lower than the air intake. |
I disagree, he said the air filter was soaking wet which indiates that the water entered through the intake. I doubt that water could make its way all the way through the exhaust and up into the manifold when the engine is running, before being sucked through the stock intake. Also if the engine hydrolocks at low revs it doesnt always cause damage, at high revs it almost always bends/breaks things due to the force of it comming to an instant stop.
Keep the revs as low as possible in 1st gear if your driving through water and think a hydrolock might be possible
Failing that stay out of lakes, ponds etc
| | |
|
|
|
| | |
| Please Dont take any of my posts as written fact. They are simply my opinion and although to the best of my knowledge true, the information within them may well be incorrect.
Any work you undertake as a result of my posts is done so at your own risk | |
| | |
|
|
|
|
|