|
Author
|
Message |
|
|
 Posted: Mon Sep 17, 2012 3:56 pm |
|
|
|
|
Joined: Sep 17, 2012
Posts: 11
Trade Rating: 0
Location: isle of wight
|
 |
Ive just been to my local tesco petrol station in my 1.4 glx which is only 3 miles away.
On the way there and back the temp gauge was just below 90 iirc.
When i got home i left the engine running for a couple of minutes while i cleaned the inside the windscreen.
I looked at the temp and it was around 95 degrees and alomst a few seconds later it shot up to the red and the dash was saying STOP.
It didnt seem to creep upto it just shot stright up!!!
Ive read a few other people with this issue but didnt know if their temps just shot up or crept up??
So whats there to look for or any suggestions?
Fuse
Relay
Switch
any photo's on the forum to show where certain things are to look for?
Thanks
phil
| |  |
|
|
 |
|
|
|
|
|
|
Posted: Mon Sep 17, 2012 4:25 pm |
|
|
|
|
Joined: Feb 07, 2010
Posts: 838
Trade Rating: +2
Location: Taking a gearbox off somewhere
|
|
It's probably not actually getting that hot, it's probably a faulty sensor. My 406's gauge moves about as it likes, one minute its cold, then its 70, then 90, then it says engine coolant temp too high, then goes off again.
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Mon Sep 17, 2012 4:47 pm |
|
|
|
|
Joined: Jul 30, 2012
Posts: 28
Trade Rating: 0
Location: Blackpool
|
|
Mine behaved like that when i got it - turned out the fan wasn't working due to corroded wires going into the relays in front of the rad.
With mine it was fine normally, sat at 90 on the temp gauge. But if i was stuck in traffic it would suddenly go into the red and flash STOP. I believe this is how plexed cars behave - the temp gauge doesn't creep up like pre-plexed systems.
Is your fan working?
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Mon Sep 17, 2012 9:18 pm |
|
|
|
|
Joined: Feb 07, 2010
Posts: 4455
Trade Rating: +1
Location: Essex
|
|
| iowphil wrote: |
Fuse
Relay
Switch |
The first things to do are check the coolent level, then run the engine & check whether the fan actually cuts in.
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Tue Sep 18, 2012 1:27 am |
|
|
|
|
Joined: Sep 17, 2012
Posts: 11
Trade Rating: 0
Location: isle of wight
|
|
Im not sure if the fan is working but I will have a look later after work,
I will also check the water levels to see what's what but yes maybe I need more coolant ( it's a high mileage car),
Thanks guys
I will post back later with what I find
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Tue Sep 18, 2012 1:28 am |
|
|
|
|
Joined: Sep 17, 2012
Posts: 11
Trade Rating: 0
Location: isle of wight
|
|
Just thought,
What temp should the fan kick in at???
| | |
|
|
|
|
|
|
|
|
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17128
Online Now [71]:
Visitors: 70
Members: 0
Staff Online Now:
Page Views:
General
Forums Home
Forum FAQ
Search
