|
Author
|
Message |
|
|
 Posted: Sun Jul 27, 2014 7:47 am |
|
|
|
|
Joined: Jul 27, 2014
Posts: 3
Trade Rating: 0
|
 |
Hi newbe here to cut a long story short i have got a wire from my battery to air con compressor and it works lovely cold air now the question is could i leave it on like this whilst the hot weather is on or do you think it would over heat? 206 1.4 x reg thanks shaun 
| |  |
|
|
 |
|
|
|
|
|
|
Posted: Sun Jul 27, 2014 8:53 am |
|
|
|
|
Joined: Feb 10, 2010
Posts: 348
Trade Rating: 0
Location: Essex
|
|
What's wrong with the original zircon wiring loom? Not sure I fully understand the question.
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Sun Jul 27, 2014 9:31 am |
|
|
|
|
Joined: Jul 27, 2014
Posts: 3
Trade Rating: 0
|
|
Hi thanks for your reply, When i switched on aircon it lit up then i got a "clicking noise from my AIR CON REGULATOR MODULE and so replaced that then i went and got a full regas from garage a full job, got home still the same .So i had find out if compressor had broke or another switch ,wired 12v from battery to ac with the wires from it and it clunked and works .so now i have it on direct all the time and wondered what would happen if i left it on untill i get switch sorted? thanks shaun
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Sun Jul 27, 2014 10:58 pm |
|
|
|
|
Joined: Feb 07, 2010
Posts: 4455
Trade Rating: +1
Location: Essex
|
|
If it's running without the key turned on it's going to run your battery down.
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Mon Jul 28, 2014 5:34 am |
|
|
|
|
Joined: Feb 07, 2010
Posts: 7093
Trade Rating: +11
Location: Suffolk
|
|
This sounds like a disaster waiting to happen, if it doesn't work get it fixed properly! Dont guess and do it yourself!
| | |
|
|
|
|
 | |  |
| Team Impossible Possible
The only way of finding the limits of the possible is by going beyond them into the impossible - Arthur C. Clarke
Forged 1.6 Turbo
Click to see more
144Bhp @ 7PSi - 193.9Bhp @ 13psi
206 Gti Race Car
Click to see more
For all Race/Track Preparation, Feel Free to PM Me!
Whether its for a custom ratio gearbox or track-day alignment, I can help! | |
 | |  |
|
|
|
|
|
|
|
Posted: Mon Jul 28, 2014 5:36 am |
|
|
|
|
Joined: Feb 07, 2010
Posts: 7093
Trade Rating: +11
Location: Suffolk
|
|
Btw check your pressures, you might have a big leak causing too little pressure which cuts out the compressor. If you sont have enough pressure the oil wont move around in the system which will damage it!
| | |
|
|
|
|
| | |
| Team Impossible Possible
The only way of finding the limits of the possible is by going beyond them into the impossible - Arthur C. Clarke
Forged 1.6 Turbo
Click to see more
144Bhp @ 7PSi - 193.9Bhp @ 13psi
206 Gti Race Car
Click to see more
For all Race/Track Preparation, Feel Free to PM Me!
Whether its for a custom ratio gearbox or track-day alignment, I can help! | |
| | |
|
|
|
|
|
|
|
Posted: Mon Jul 28, 2014 11:43 am |
|
|
|
|
Joined: Jul 27, 2014
Posts: 3
Trade Rating: 0
|
|
Thanks for your help, this where am at .Now i know my air con is fully gassed and no leaks , i have taken the lead from car to compressor and put a volt tester on it . Now when i start car everything is normal ,now with voltmeter on i switch on air con , i get power through on 1, 2 on blower, then after a 2 min or so i hear clicking from my AIR CON REGULATOR MODULE and the volts jump all over the place .So what could cause such a disruption in power ? this also hapens if i rev up engine any help please thanks
| | |
|
|
|
|
|
|
|
|
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17128
Online Now [336]:
Visitors: 335
Members: 0
Staff Online Now:
Page Views:
General
Forums Home
Forum FAQ
Search
