|
Author
|
Message |
|
|
 Posted: Mon May 16, 2011 4:28 am |
|
|
|
|
Joined: Mar 17, 2010
Posts: 139
Trade Rating: 0
Location: uk
|
 |
My 206 drivers side head lamp hit a bumper pushing my headlamp in. when i opened my bonnet i can see the bracket is snapped clean away from headlamp housing indiciated by the two yellow lines in library picture.
is a whole new headlamp required. or the back of the plastic can be replaced?
i also noticed there was condensation in headlamp in the mornign (never had it before) but i cant see any crack where the moisture may have got it ?
this is damage :
Uploaded with ImageShack.us
| |  |
|
|
 |
Last edited by leon206 on Mon May 16, 2011 4:37 am; edited 3 times in total
|
|
|
|
|
|
|
Posted: Mon May 16, 2011 4:34 am |
|
|
|
|
Joined: Feb 08, 2010
Posts: 6055
Trade Rating: +53
Location: Salisbury / New Forest
|
|
Is the rear cover on properly?
I wouldn't worry about the damaged bracket.
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Mon May 16, 2011 4:40 am |
|
|
|
|
Joined: Mar 17, 2010
Posts: 139
Trade Rating: 0
Location: uk
|
|
thats the problem. i dont know how far the headlamp has been pushed in. if i look at it with the bonnet closed. the bottom half of headlamp gap lines are OK. its just as it gets near to the top you can notice a gap.
if i try stick my hand down gap behind headlamp and change the side light or remove the washer bottle neck i am near enough unable to fit my hand in .
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Mon May 16, 2011 4:46 am |
|
|
|
|
Joined: Dec 16, 2010
Posts: 1533
Trade Rating: +10
Location: UK
|
|
for the cost of them second hand I would just replace it dude  (providing nothing around the headlamp is damaged also)
The condensation could be because the covers not on properly as said or because the lamp has been stressed breaking the waterproof seal somewhere (its really hard to see where). In my experience once a headlight starts "steaming" its really difficult to get it to stop haha, you can get rid of it with a hairdryer and 10 mins (blowing into the headlight) but enless you find how waters getting in it will just return.
Also with the damage on the headlamp, its possible (i doubt it but you never know) it could alter the beam pattern causing you MOT issues?
For the cost of a second hand one (could probs pick a single one up on ebay) id change it 
| | |
|
|
|
|
 | |  |
| Please Dont take any of my posts as written fact. They are simply my opinion and although to the best of my knowledge true, the information within them may well be incorrect.
Any work you undertake as a result of my posts is done so at your own risk | |
 | |  |
|
|
|
|
|
|
|
Posted: Mon May 16, 2011 4:52 am |
|
|
|
|
Joined: Feb 07, 2010
Posts: 4117
Trade Rating: +25
Location: No Man's Land
|
|
It won't be your light thats out of place it will have bent your headlamp surround out of place, take the headlight out and reshape it with a block of wood and hammer and refit. The light should sit properly, you don't really need the top bracket if the other two brackets are in the correct place.
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Mon May 16, 2011 5:00 am |
|
|
|
|
Joined: Mar 17, 2010
Posts: 139
Trade Rating: 0
Location: uk
|
|
its OK. insurance are paying for it who went into me. so ill just tell the garage to make sure they replace it then. thanks.
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Mon May 16, 2011 5:02 am |
|
|
|
|
Joined: Dec 16, 2010
Posts: 1533
Trade Rating: +10
Location: UK
|
|
wont you loose your no claims over that?
| | |
|
|
|
|
| | |
| Please Dont take any of my posts as written fact. They are simply my opinion and although to the best of my knowledge true, the information within them may well be incorrect.
Any work you undertake as a result of my posts is done so at your own risk | |
| | |
|
|
|
|
|
|
|
Posted: Mon May 16, 2011 5:20 am |
|
|
|
|
Joined: Mar 17, 2010
Posts: 139
Trade Rating: 0
Location: uk
|
|
no its third partys fault
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Mon May 16, 2011 6:45 am |
|
|
|
|
Joined: Mar 29, 2010
Posts: 3977
Trade Rating: +15
Location: Halifax
|
|
I had a similar problem and you broke the other bracket on the new one putting it in!
| | |
|
|
|
|
|
|
|
|
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17128
Online Now [84]:
Visitors: 83
Members: 0
Staff Online Now:
Page Views:
General
Forums Home
Forum FAQ
Search
