Author
|
Message |
|
Posted: Mon Jun 25, 2012 4:43 pm |
|
|
|
Joined: May 28, 2012 Posts: 9
Trade Rating: 0
Location: Edinburgh
|
|
Hi,
I have peugeot 206 1.4 1999. I am loosing the coolant, no leaks can be seen and oil looks good - no coolant in there, also no white smoke in exhaust.
Spark plugs were checked in garage today as car is misfiring a little.
Today on a short trip home the temp gauge went bit over 90 and than straight into red in like 5 sec. Stopped for 2 - 3 min started again and temp. was back to normal.
At home checked the coolant level after engine cooled down a little and it was fine. Heated it up to working temp. and it did not overheat. Left it for another half an hour and the coolant was gone again from the reservoir?
Where could the coolant go?
| | |
|
|
|
|
|
|
|
Posted: Mon Jun 25, 2012 4:50 pm |
|
|
|
Joined: Feb 08, 2010 Posts: 10151
Trade Rating: +12
|
|
this looks like you got air in the coolant system
| | |
|
|
|
|
|
|
|
Posted: Mon Jun 25, 2012 4:59 pm |
|
|
|
Joined: May 28, 2012 Posts: 9
Trade Rating: 0
Location: Edinburgh
|
|
Seabook wrote: |
this looks like you got air in the coolant system |
that would make sense - when I was removing the cup it let quite a lot of air out.
How to get that air out?
| | |
|
|
|
|
|
|
|
Posted: Mon Jun 25, 2012 5:18 pm |
|
|
|
Joined: Feb 24, 2010 Posts: 2596
Trade Rating: +17
Location: North West Wales
|
|
look at the 2 black pipes on the right of the engine that go through the bulkhead, there's a valve on there.
| | |
|
|
|
|
|
|
|
Posted: Tue Jun 26, 2012 7:49 am |
|
|
|
Joined: Nov 27, 2010 Posts: 11519
Trade Rating: +10
Location: What's it to you? ? ?
|
|
Just bled the air out of my cooling system after doing the timing belt kit & water pump.
Bleed screw on the coolant pipe next to the bulkhead & also a blank you can remove just behind the thermostat on the housing ( early 206's might have a 2nd temp sensor screwed in here )
| | |
|
|
|
| | |
| Toyota C-HR GR Sport 2.0 Hybrid with JBL & Alcantara packs. | |
| | |
|
|
|
|
|
Posted: Tue Jun 26, 2012 11:18 am |
|
|
|
Joined: May 28, 2012 Posts: 9
Trade Rating: 0
Location: Edinburgh
|
|
Thanks for your replies.
I will take it to garage in the morning. Im still afraid that it will be head gasket - but at least I have a hope for air in the system.
| | |
|
|
|
|
|
|
|
Posted: Wed Jun 27, 2012 2:42 am |
|
|
|
Joined: May 28, 2012 Posts: 9
Trade Rating: 0
Location: Edinburgh
|
|
Thermostat needed to be replaced as it was stuck and coolant was blown out through radiator cup.
| | |
|
|
|
|
|
|
|