|
Author
|
Message |
|
|
 Posted: Thu Jan 26, 2012 3:03 pm |
|
|
|
|
Joined: Aug 04, 2011
Posts: 1343
Trade Rating: 0
Location: Swindon
|
 |
Yes the lead is a cheap Chinese clone but it will connect to my wife's Alfa 159 (9/10 times) and to my son's Alfa 147 (8/10 times.) However it will not connect to my daughter's 1.4 8V 206 "W" reg.
I have set the bit rate and port number correctly (it wouldn't connect to the other cars if that was wrong) and also unplugged and reconnected to the car about 15 times hoping that would clean any dirty pins.
I am now lost for a way forward.
Is it just that the Peugeot is more fussy of cloned leads than the Alfa or should I be looking for damaged plug or disconnected wires on the car interface.
EasyOBDII will get past the "Vehicle data bus" but fails at the "vehicle rsponce."
ScanMaster-ELM will find the port, report the battery voltage but reports "protocol unknown" and then reports "please wait for connection" then shows "no connection to ECU"
OBD2Spy gets to "M1: requesting supported PIDs" and then gives lots of "Port Closed" messages before a popup box with a runtime error.
| |  |
|
|
 |
 | |  |
| Morris 1000, Austin 1100, Escort Mk2, Fiat Mirafiori, Alfa 33, Alfa GT Junior, Alfasud, Alfetta GTV (2x), Alfa 164 3.0 V6, Alfa 164 2.0, Alfa 75 V6, Alfa 156 2.4 (diesel remapped 200bhp), Alfa 147 GTA (3.6 295bhp), Alfa 159 (diesel remapped 245bhp 300ft.lbs @ 2500rpm)
Why isn't my daughter an Alfaholic? | |
 | |  |
|
|
|
|
|
|
|
Posted: Thu Jan 26, 2012 3:17 pm |
|
|
|
|
Joined: Feb 07, 2010
Posts: 13077
Trade Rating: +65
Location: England
|
|
It's not EOBD that's why
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Thu Jan 26, 2012 3:21 pm |
|
|
|
|
Joined: Aug 04, 2011
Posts: 1343
Trade Rating: 0
Location: Swindon
|
|
Lee: I thought that the engine ECU was OBD2. Shouldn't OBD2Spy or ScanMaster have connected? My wife's 159 is definitely OBD2 and that connects with both ScanMaster and OBD2Spy.
| | |
|
|
|
|
| | |
| Morris 1000, Austin 1100, Escort Mk2, Fiat Mirafiori, Alfa 33, Alfa GT Junior, Alfasud, Alfetta GTV (2x), Alfa 164 3.0 V6, Alfa 164 2.0, Alfa 75 V6, Alfa 156 2.4 (diesel remapped 200bhp), Alfa 147 GTA (3.6 295bhp), Alfa 159 (diesel remapped 245bhp 300ft.lbs @ 2500rpm)
Why isn't my daughter an Alfaholic? | |
| | |
|
|
|
|
|
|
|
Posted: Thu Jan 26, 2012 3:26 pm |
|
|
|
|
Joined: Feb 08, 2010
Posts: 10151
Trade Rating: +12
|
|
after 2001 for petrol and 2004 for diesel.
W reg is 2000; won't support OBD II
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Thu Jan 26, 2012 3:32 pm |
|
|
|
|
Joined: Feb 07, 2010
Posts: 13077
Trade Rating: +65
Location: England
|
|
OBDII is American
EOBD is European
It's not EOBD
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Thu Jan 26, 2012 3:33 pm |
|
|
|
|
Joined: Aug 04, 2011
Posts: 1343
Trade Rating: 0
Location: Swindon
|
|
Does this make it PP only then? It does have an OBD ELM shaped connector. Is there other software that will work with the ELM327. My Alfas will connect with both KKL and ELM using different software.
| | |
|
|
|
|
| | |
| Morris 1000, Austin 1100, Escort Mk2, Fiat Mirafiori, Alfa 33, Alfa GT Junior, Alfasud, Alfetta GTV (2x), Alfa 164 3.0 V6, Alfa 164 2.0, Alfa 75 V6, Alfa 156 2.4 (diesel remapped 200bhp), Alfa 147 GTA (3.6 295bhp), Alfa 159 (diesel remapped 245bhp 300ft.lbs @ 2500rpm)
Why isn't my daughter an Alfaholic? | |
| | |
|
|
|
|
|
|
|
Posted: Thu Jan 26, 2012 3:35 pm |
|
|
|
|
Joined: Feb 07, 2010
Posts: 13077
Trade Rating: +65
Location: England
|
|
Actia based diag only
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Thu Jan 26, 2012 3:37 pm |
|
|
|
|
Joined: Aug 04, 2011
Posts: 1343
Trade Rating: 0
Location: Swindon
|
|
Actia? Never heard of that one. What cable and where do I get the software please.
| | |
|
|
|
|
| | |
| Morris 1000, Austin 1100, Escort Mk2, Fiat Mirafiori, Alfa 33, Alfa GT Junior, Alfasud, Alfetta GTV (2x), Alfa 164 3.0 V6, Alfa 164 2.0, Alfa 75 V6, Alfa 156 2.4 (diesel remapped 200bhp), Alfa 147 GTA (3.6 295bhp), Alfa 159 (diesel remapped 245bhp 300ft.lbs @ 2500rpm)
Why isn't my daughter an Alfaholic? | |
| | |
|
|
|
|
|
|
|
Posted: Thu Jan 26, 2012 3:37 pm |
|
|
|
|
Joined: Feb 07, 2010
Posts: 13077
Trade Rating: +65
Location: England
|
|
|
|
|
|
|
|
|
|
|
Posted: Thu Jan 26, 2012 3:43 pm |
|
|
|
|
Joined: Aug 04, 2011
Posts: 1343
Trade Rating: 0
Location: Swindon
|
|
Ouch. Well I'm not paying that much just to find out if it is gauge, sensor or thermostat that is the cause of 70 degree water temp reading.
Especially as the heater gets really hot and the dash temp gauge needle is rock solid on 70 even when stationary for 30 mins. That must be either gauge or sensor. My money is now on sensor.
If it's sending a low temp signal then it's probably also running a bit rich (although plugs were a pretty good colour) so I will change the sensor.
| | |
|
|
|
|
| | |
| Morris 1000, Austin 1100, Escort Mk2, Fiat Mirafiori, Alfa 33, Alfa GT Junior, Alfasud, Alfetta GTV (2x), Alfa 164 3.0 V6, Alfa 164 2.0, Alfa 75 V6, Alfa 156 2.4 (diesel remapped 200bhp), Alfa 147 GTA (3.6 295bhp), Alfa 159 (diesel remapped 245bhp 300ft.lbs @ 2500rpm)
Why isn't my daughter an Alfaholic? | |
| | |
|
|
|
|
|
|
|
Posted: Thu Jan 26, 2012 3:45 pm |
|
|
|
|
Joined: Feb 07, 2010
Posts: 13077
Trade Rating: +65
Location: England
|
|
Mines runs at 70. Has done for all 4 years I've owned it, and there is nothing wrong.
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Thu Jan 26, 2012 3:48 pm |
|
|
|
|
Joined: Aug 04, 2011
Posts: 1343
Trade Rating: 0
Location: Swindon
|
|
I thought only Alfas had electrical gremlins!
| | |
|
|
|
|
| | |
| Morris 1000, Austin 1100, Escort Mk2, Fiat Mirafiori, Alfa 33, Alfa GT Junior, Alfasud, Alfetta GTV (2x), Alfa 164 3.0 V6, Alfa 164 2.0, Alfa 75 V6, Alfa 156 2.4 (diesel remapped 200bhp), Alfa 147 GTA (3.6 295bhp), Alfa 159 (diesel remapped 245bhp 300ft.lbs @ 2500rpm)
Why isn't my daughter an Alfaholic? | |
| | |
|
|
|
|
|
|
|
Posted: Thu Jan 26, 2012 3:50 pm |
|
|
|
|
Joined: Nov 27, 2010
Posts: 11520
Trade Rating: +10
Location: What's it to you? ? ?
|
|
| Lee wrote: |
| Mines runs at 70. Has done for all 4 years I've owned it, and there is nothing wrong. |
Yours is diesel & they run cooler then petrols 
| | |
|
|
|
|
| | |
| Toyota C-HR GR Sport 2.0 Hybrid with JBL & Alcantara packs. | |
| | |
|
|
|
|
|
|
|
Posted: Thu Jan 26, 2012 3:58 pm |
|
|
|
|
Joined: Feb 07, 2010
Posts: 13077
Trade Rating: +65
Location: England
|
|
| MrBSI wrote: |
| Lee wrote: |
| Mines runs at 70. Has done for all 4 years I've owned it, and there is nothing wrong. |
Yours is diesel & they run cooler then petrols |
I know they do. Didn't know his was petrol. Just knew it wasn't EOBD from the title.
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Thu Jan 26, 2012 3:59 pm |
|
|
|
|
Joined: Feb 07, 2010
Posts: 13077
Trade Rating: +65
Location: England
|
|
Run K-line from ELM direct to ECU
| | |
|
|
|
|
|
|
|
|
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17129
Online Now [90]:
Visitors: 89
Members: 0
Staff Online Now:
Page Views:
General
Forums Home
Forum FAQ
Search
