|
Author
|
Message |
|
|
 Posted: Wed Mar 14, 2012 8:33 am |
|
|
|
|
Joined: Feb 07, 2010
Posts: 150
Trade Rating: 0
Location: United Kingdom
|
 |
Tearing my hair out over the 206 as usual. 
Whenever I move away at a junction I get this blowing noise coming from the front of the car. It sounds just like an exhaust blowing. However the noise does not happen on idle, or if it is revved in neutral. It only happens when accelerating.
The whole exhaust system is new since December 2011 and two garages have ruled out any exhuast / catalyst problem.
I've taken the car to the local dealer and an independent garage and neither can establish for sure whats causing the noise. However they have both advised that it might be the spring bolts between the catalyst and the front pipe.
The independent suggested I go back to Peugeot as they cant be sure. Peugeot arent sure either and are estimating this could run into hundreds of pounds to diagnose and fix.
Searching this forum doesnt bring up any posts that match the issue precisely.. leaving me in quite a conundrum.
Has anyone heard of a 206 making blowing and rattling noises from the front when accelerating that are not related to the exhaust system?
Any advice would be most appreciated before I take it in 
| |  |
|
|
 |
|
|
|
|
|
|
Posted: Wed Mar 14, 2012 10:40 am |
|
|
|
|
Joined: Feb 20, 2012
Posts: 64
Trade Rating: 0
Location: North wales
|
|
What state is the exhaust manifold head sheild in? They tend to work lose and rattle.
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Wed Mar 14, 2012 10:50 am |
|
|
|
|
Joined: Feb 07, 2010
Posts: 150
Trade Rating: 0
Location: United Kingdom
|
|
Not sure if the head shield has been checked. Is it an easy thing to find and check?
Would it also cause a blowing noise if it has a problem?
Thanks
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Thu Mar 15, 2012 4:29 am |
|
|
|
|
Joined: Feb 20, 2012
Posts: 64
Trade Rating: 0
Location: North wales
|
|
Sorry that was a typo, should have written heat sheild. Its just a metal surround that sits over the exhaust manifold.
The blowing sound, wouldn't be an induction roar would it? Split in your intake pipe?
I'll find a heat sheild pic now...
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Thu Mar 15, 2012 4:37 am |
|
|
|
|
Joined: Feb 20, 2012
Posts: 64
Trade Rating: 0
Location: North wales
|
|
|
Its the silver half circle thing at the front, lambda sensor poking out of it. Just a thin metal cover. When the engine is cold have a good pull of it, see if the bolt holes are worn/broken and if there is much play in it.
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Thu Mar 15, 2012 5:44 pm |
|
|
|
|
Joined: Feb 07, 2010
Posts: 150
Trade Rating: 0
Location: United Kingdom
|
|
| Bummers wrote: |
Sorry that was a typo, should have written heat sheild. Its just a metal surround that sits over the exhaust manifold.
The blowing sound, wouldn't be an induction roar would it? Split in your intake pipe?
I'll find a heat sheild pic now... |
It is indeed an induction roar, its pretty loud but only when pulling away.
Perhaps the intake pipe is split? From what Peugeot are saying they cant get to the part they need without £££ worth of investigation. If the in-take pipe is split will it really cost alot of £££ to fix? 
Thanka for pointing out the heat shield - i'll be checking that out tomorrow!
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Fri Mar 16, 2012 2:21 am |
|
|
|
|
Joined: Feb 20, 2012
Posts: 64
Trade Rating: 0
Location: North wales
|
|
Ignore them monkeys - i really hate dealerships! Very easy to check yourself, just take the pipe off that runs between the throttle body & the air box, look for any cracks, splits, holes etc.
Make sure the airbox is seated and sealed correctly. Whilst you're at it check your air filter is ok.
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Thu Apr 18, 2013 5:22 pm |
|
|
|
|
Joined: Feb 20, 2013
Posts: 28
Trade Rating: 0
|
|
Any more progress on this by chance my friend?!
I ask as my car is making a resonating kind of noise which only happens at 2000rpm when accelerating....
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Thu Apr 18, 2013 5:59 pm |
|
|
|
|
Joined: Feb 07, 2010
Posts: 150
Trade Rating: 0
Location: United Kingdom
|
|
| LloydPug206 wrote: |
Any more progress on this by chance my friend?!
I ask as my car is making a resonating kind of noise which only happens at 2000rpm when accelerating.... |
Hi
I never solved this I'm afraid. Despite getting a number of opinions. No one was able to identify the cause without taking out the engine. However the dealer I sold the car to didn't seem too concerned about- the problem, so not sure what to think!
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Fri Apr 19, 2013 7:59 am |
|
|
|
|
Joined: Feb 07, 2010
Posts: 2949
Trade Rating: +6
Location: Athens, Greece
|
|
Check:
Exhaust manifold gasket
Exhaust bottom spring flexi-joint gasket (mid-pipe to cat coupling assembly)
Intake/exhaust valve tappet clearance (esp. if revs 'hang')
| | |
|
|
|
|
 | |  |
| 1.4i, 2001, 3-door, China Blue
Repair safely - Drive safely | |
 | |  |
|
|
|
|
|
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17130
Online Now [499]:
Visitors: 498
Members: 0
Staff Online Now:
Page Views:
General
Forums Home
Forum FAQ
Search
