|
Author
|
Message |
|
|
 Posted: Thu Jan 16, 2014 1:19 am |
|
|
|
|
Joined: Jan 15, 2014
Posts: 6
Trade Rating: 0
|
 |
hello all. lately my Peugeot 206 (2001), has been playing up it will drive normally and then all of a sudden if you put your foot on the gas pedal you get no more power out of it. and the more you press the pedal down the more the engine seems to choke. and the car also shakes . and the car all of a sudden sound like a vw beetle ... it's been happening on and off. but it's happening more often. I have read it might be the coil or spark plugs or it might be the jets. does anyone have any info on this problem to share as it would be very much appreciated
thank you
| |  |
|
|
 |
|
|
|
|
|
|
Posted: Thu Jan 16, 2014 2:34 pm |
|
|
|
|
Joined: Feb 07, 2010
Posts: 5120
Trade Rating: +19
Location: Raunds, Northamptonshire
|
|
check spark plugs 1st, does it smell of petrol out of the exhaust? but could be a coilpack.
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Fri Jan 17, 2014 2:40 pm |
|
|
|
|
Joined: Jan 15, 2014
Posts: 6
Trade Rating: 0
|
|
Thanks for that info.. I have ordered a coil pack and a fuel filter for now and I will go from there... do you have any idea how you get the plugs out of this car.. as they are at the back of the engine... and are at quite a sharp angle..
cheers...
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Sat Jan 18, 2014 5:55 am |
|
|
|
|
Joined: Jun 14, 2010
Posts: 59
Trade Rating: 0
Location: Devon
|
|
Hi. Getting the plugs out is tricky but straightforward.
You need to remove the coil pack first, this is done by removing the centre wiring plug and carefully removing the wiring loom from the coil pack.
Next locate the two nuts one at each end of the coil pack 10mm or 12mm I think. remove these on the left hand end there are sometimes two nuts one below the other with a bracket in between.
With these removed the coil pack can be pulled out it is a tight fit and can need some force sometimes.
Then you can see the plugs, The best way is to use a normal plug socket in conjunction with a universal/swivel joint to make the access easier, once the plugs are loose in the tubes I normally use a telescopic magnet to pull them out.
Installation is basically a reverse procedure pls be careful with the coil pack, and make sure it slides over the plugs.
Hope this helps.
Neil
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Sat Jan 18, 2014 6:19 am |
|
|
|
|
Joined: Jan 29, 2011
Posts: 6526
Trade Rating: +10
Location: Westhoughton, Lancashire
|
|
If you can get hold of a spark plug socket with the rubber grommet in, it makes life easier to both remove and refit the plugs. Short extension with a knuckle joint or better still a flexible extension is useful.
Don't be tempted to start throwing the ratchet round as soon as you put the plug back in. It's very easy to cross thread and ruin the head. Just use the socket and extension in your hand and get the plugs finger tight so you can feel any resistance from the plug not being straight.
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Mon Jan 20, 2014 10:52 am |
|
|
|
|
Joined: Jan 15, 2014
Posts: 6
Trade Rating: 0
|
|
Hello.
My peugeot 206 drove fine for a few months and then all of a sudden the engine would really chugg and shake more than normal... I have just changed the coil pack. But its still no good. There is not much power in the car and its chugging as much as ever now but also there's a lot more smoke coming from the exhaust... and it undrivable.. I have got a fuel fillter coming.. and maybe I will get the spark plugs out and take a look at them when I get a spark plug spanner for it.. has anyone had the same problem .. or has anyone
got some advice on what else it might be. As I am quite a novice on engines
Thanks...
Merged with your previous topic of the same problem - Macca1411
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Tue Jan 21, 2014 5:43 am |
|
|
|
|
Joined: Nov 14, 2013
Posts: 130
Trade Rating: 0
|
|
Mine was a fuel injector.
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Tue Jan 21, 2014 11:25 am |
|
|
|
|
Joined: Feb 07, 2010
Posts: 5120
Trade Rating: +19
Location: Raunds, Northamptonshire
|
|
if you don't have a socket with rubber bit on i sometimes take a plug off the coil pack and push it into hole to pull spark plug out,
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Tue Jan 21, 2014 11:58 am |
|
|
|
|
Joined: Aug 04, 2011
Posts: 1343
Trade Rating: 0
Location: Swindon
|
|
Or a pair of long nose pliers. Though they don't really help refit.
When refitting lots of people drop the plugs into the hole then put the plug spanner on. You can cause the plug gap to close up doing it that way.
| | |
|
|
|
|
 | |  |
| Morris 1000, Austin 1100, Escort Mk2, Fiat Mirafiori, Alfa 33, Alfa GT Junior, Alfasud, Alfetta GTV (2x), Alfa 164 3.0 V6, Alfa 164 2.0, Alfa 75 V6, Alfa 156 2.4 (diesel remapped 200bhp), Alfa 147 GTA (3.6 295bhp), Alfa 159 (diesel remapped 245bhp 300ft.lbs @ 2500rpm)
Why isn't my daughter an Alfaholic? | |
 | |  |
|
|
|
|
|
|
|
Posted: Tue Jan 21, 2014 1:49 pm |
|
|
|
|
Joined: Jan 29, 2011
Posts: 6526
Trade Rating: +10
Location: Westhoughton, Lancashire
|
|
| kandlbarrett wrote: |
Or a pair of long nose pliers. Though they don't really help refit.
When refitting lots of people drop the plugs into the hole then put the plug spanner on. You can cause the plug gap to close up doing it that way. |
A piece of garden hose pushed onto the insulator can be used at a push.
| | |
|
|
|
|
|
|
|
|
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17129
Online Now [123]:
Visitors: 122
Members: 0
Staff Online Now:
Page Views:
General
Forums Home
Forum FAQ
Search
