|
Author
|
Message |
|
|
 Posted: Sat Jun 18, 2011 3:04 pm |
|
|
|
|
Joined: Feb 07, 2011
Posts: 9
Trade Rating: 0
Location: Lincolnshire
|
 |
Hi all,
My 2004 gti hdi 110hp has had many problems but the most recent being that the engine management light shows and the message anti pollution fault displayed, i've checked the fault codes recorder which states iat sensor, what is this and where is it located? the car seems low on power and is very jerky at low speed. Also had a problem with a front wheel bearing which caused wheel wobble under braking. I changed the bearing and discs etc which cured the problem but within 3k miles it has re appeared. would you assume the hub itself is faulty? any advice much appreciated, thanks
| |  |
|
|
 |
|
|
|
|
|
|
Posted: Sat Jun 18, 2011 3:19 pm |
|
|
|
|
Joined: Jan 13, 2011
Posts: 664
Trade Rating: 0
Location: aldershot
|
|
might be other side now, or was it a second hand hub?
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Sat Jun 18, 2011 3:37 pm |
|
|
|
|
Joined: May 26, 2011
Posts: 4
Trade Rating: 0
Location: milton keynes
|
|
Intake air temp sensor
Its either combined with the mass air flow sensor (maf)
Or its on its own in the pipe from the aircleaner
To tbe turbom
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Sat Jun 18, 2011 3:41 pm |
|
|
|
|
Joined: Feb 07, 2010
Posts: 3666
Trade Rating: +59
Location: Scotland
|
|
Change the discs and pads. Should have done this before replacing the bearing, which normally makes a drone if it's knackered.
Sounds like the DPF filter may require regeneration as well. Have a search as it's been covered loads of times.
| | |
|
|
|
|
 | |  |
| '98 Nile Blue 306 GTi 6
'04 Obsidian Black 206 GTi 138 | |
 | |  |
|
|
|
|
|
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17129
Online Now [61]:
Visitors: 60
Members: 0
Staff Online Now:
Page Views:
General
Forums Home
Forum FAQ
Search
