|
Author
|
Message |
|
|
 Posted: Thu Jan 21, 2016 9:07 am |
|
|
|
|
Joined: Feb 07, 2010
Posts: 35
Trade Rating: 0
Location: Norfolk
|
 |
Hi Guys,
Quick question for you. Where do I measure to and from to get the height of the axle? My axle needs to come off and go away to be repaired (under warrenty). If the axle needs to be replaced then I need the axle people to set the height for me, all they need is the measurement. I will ask them but just seeing if any of you chaps know.
Cheers
| |  |
|
|
 |
|
|
|
|
|
|
Posted: Sun Jan 24, 2016 5:06 pm |
|
|
|
|
Joined: Dec 20, 2015
Posts: 12
Trade Rating: 0
|
|
HI, if your taking the axle off complete and sending it back for repairing,
ie, (replacing radius bearings), they will do all the settings,
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Mon Jan 25, 2016 1:31 am |
|
|
|
|
Joined: Feb 07, 2010
Posts: 35
Trade Rating: 0
Location: Norfolk
|
|
Hi,
Sadly they don't know the height that its been set to, so when it comes to replacing or fixing they need a height to reference. Apparently they have a jig setup where they can adjust the axle height, all they need to know is this reference height. I have now been informed that the height they require is from the stub pin to the bottom of the boot.
Cheers
| | |
|
|
|
|
|
|
|
|
|
|
Posted: Mon Jan 25, 2016 1:53 pm |
|
|
|
|
Joined: Dec 20, 2015
Posts: 12
Trade Rating: 0
|
|
Hi, When i renewed the o/s radius bearings on my axle i measured the distance from the rear plate of the trailing arm up to the underside of the floor which was seven and a half inches, worked fine,
| | |
|
|
|
|
|
|
|
|
Membership:
Latest: 
New Today: 0
New Yesterday: 0
Overall: 17130
Online Now [101]:
Visitors: 100
Members: 0
Staff Online Now:
Page Views:
General
Forums Home
Forum FAQ
Search
